雙組份打膠機在使用中應該怎樣維護
1.由于雙組份打膠機密封膠的固化需要一定時間,因此,已涂了雙組份打膠機密封膠的玻璃應水平輕輕搬動.
1. Due to the two-component glue confidential sealing glue curing need for a certain period of time, therefore, has painted two copies of glue confidential sealing glue glass should horizontal to gently move.
2.雙組份打膠機的A組、B組份膠應保持清潔,嚴防異物進入膠中.
The 2 two-component atx-ii A group, B group portion of the glue should be kept clean, to prevent the foreign body into the glue.
3.在連續工作過程中,膠槍每次停止工作時間一般不得超過20分鐘,否則,應用A組份膠沖出全部混合膠,直單一的A組份膠從槍口排出為止.
3 in the process of continuous work, the glue gun to stop working time is generally not more than 20 minutes, otherwise, the application of A group of plastic out of all the mixed rubber, until a single A group of rubber from the muzzle.
4.雙組份打膠機的高壓膠管不得強行擠壓、彎曲,防止影響系統正常工作.
4 pairs of sets of plastic machine of the high pressure hose shall not force the extrusion, bending, to prevent the impact of the system to work normally.
5.混膠器應經常保持暢通,以保證良好的出膠效果.如遇堵塞情況,可用丙酮浸泡后清洗.建議每5組清洗一次.
5 the rubber mixing machine should always keep the flow, in order to ensure the good result. If the case of the case of the plug, can be cleaned with acetone. It is recommended that every 5 groups be cleaned once.
6.當的膠槍長時間不用時(超過一周),應拆下槍體使用溶劑將膠槍和混膠器內的殘留膠體清洗干凈.
6 when the glue gun is not used for a long time (more than a week), the body of the gun should be removed and the residual colloid in the glue gun and the mixture is cleaned.
7.不同雙組份膠生產廠家所生產的膠內含雜質數量不同,根據實際情況清晰B組分的過濾網及單向止回閥,建議每兩組清洗一次
7 different pairs of rubber production factory produced by the number of different impurities, according to the actual situation of clear B component of the filter and check valve, recommended every two groups of cleaning
8.定期給各泵的加油口加油,應保證油霧器內不斷油.
8 regularly to the pump of the oil gas, should ensure that the oil mist device continuously.
了解了雙組份打膠機的日常維護要點后,相信您也懂得了應該怎么來維護您的雙組份打膠機了吧.
Understanding of the two groups of parts of the machine after the maintenance of the daily maintenance, I believe you also know how to maintain your double set of plastic machine.
上一篇：中空玻璃設備的強度和硬度是如何進行分別的？
下一篇：旋轉軸自動點膠可以提升圓形點膠效果嗎？
